Skip forward into hiring notes
RosterAcorn

Oregon travel time pay: 9 pre-placement checks

In Oregon, employer-required travel to an alternate site over 30 miles from the normal fixed work location generally must be paid ( BOLI).

Key takeaways

  • Record the worker's normal fixed work location.
  • Measure the distance and confirm the employer's travel requirement.
  • Give payroll regular hours and both trip schedules before departure.

Why the 30-mile line matters

That sentence is short, but it does most of the work. It turns a question recruiters should consider into a payroll question. If a worker raises the question after the trip is booked, the times may already be set.

Travel time can be work time, so it deserves the same care as the rest of the shift. The federal Department of Labor makes a related point, which we cover later in this post.

This post explains the rule in plain terms, separately walks through BOLI's normal-hours example with a worker named Chet, and gives you a checklist for placements that cross the 30-mile line. It is general information, not legal advice. For a specific placement, check the BOLI pages directly or ask your employment counsel.

Start with the normal work location

Before you can tell whether a trip crosses the 30-mile line, you need to know where the worker's normal work location is. BOLI measures distance from the worker's "normal fixed work location," so that is the first point to pin down. It is the place the worker normally reports to, and it should be written down in the worker's file.

Write it down. For each worker, record the address of the regular work location and the schedule the worker normally keeps. A clear record protects the worker and your company, and it makes the distance question quick to answer when a new assignment comes up.

Recruiters who place people across several client sites should also keep the words "site" and "location" straight. A temporary assignment at a client's office away from the worker's normal fixed work location may be an alternate work site. The place where the worker is normally based is the fixed location. Keep the two separate in your placement notes so nobody has to guess later which one a trip was measured from.

If a worker has more than one regular place, treat that as a case to review before the first assignment, not after it.

What BOLI's rule says

BOLI's travel page makes three points that are worth reading closely.

The first is the trigger, which is an employer requirement. The rule is about a worker the employer requires to report to the alternate site. For a worker who takes a farther job on their own, ask counsel to review the circumstances before deciding how travel should be paid.

The second is distance. The test is an alternate site "over 30 miles away" from the normal fixed work location. Note the word "over." When a site sits close to the line, measure carefully and write down how you measured.

The third is the default. The employer "generally" must pay for that travel time. The word matters. It describes a starting point rather than a guarantee for every trip, and the facts of each case still count. It is not permission to skip the question, either.

BOLI's page also includes a single-day assignment. That separate example concerns travel to a city beyond a 30-mile radius of the official work location, and it concludes that the travel time involved must be paid. Do not dismiss an assignment because it lasts only a day.

Meet Chet

BOLI uses a worker named Chet to illustrate travel overlapping normal work hours separately from the distance rule. Chet's regular work schedule is 8:00 a.m. to 5:00 p.m., Monday through Friday. That schedule is the baseline for the Saturday overlap illustrated below.

The example then adds two trips:

  • On Wednesday, Chet travels by bus from 10:00 a.m. to 4:00 p.m.
  • On Saturday, Chet returns home by bus, traveling from 2:00 p.m. to 8:00 p.m.

The key sentence follows: the employer must pay for the three hours between 2:00 and 5:00 p.m., the travel time which cuts across Chet's normal work hours.

Two details deserve attention. First, the window is defined by overlap. The example pays for the portion of travel that cuts across the regular hours. That is a different idea from paying for every hour someone is on a bus. Second, Saturday is not one of the Monday-through-Friday days in Chet's schedule, so the overlap logic is worth reading closely in the full BOLI page before you apply it to your own shifts. Your payroll team or counsel should confirm how it fits your schedules.

Working through the numbers

Examples are easier to follow with the arithmetic written out. Here is the breakdown, using only the times in BOLI's example:

  • Regular schedule: 8:00 a.m. to 5:00 p.m., Monday through Friday.
  • Wednesday bus trip: 10:00 a.m. to 4:00 p.m., which is six hours on the clock and falls inside the regular workday.
  • Saturday return: 2:00 p.m. to 8:00 p.m., which is six hours on the clock.
  • Saturday, 2:00 to 5:00 p.m.: three hours that overlap the regular hours.
  • Saturday, 5:00 to 8:00 p.m.: three hours after that window; ask payroll to review their treatment separately.

For Chet's Saturday window, comparing the travel times with his normal hours identifies the overlap; it does not calculate all pay due under the distance rule.

It also helps to write the calculation next to the placement itself. When a payroll question comes up later, a line that shows the regular hours, the planned travel hours, and the overlap saves a lot of guessing.

Illustrative example: recording overlap

An illustrative trip lasts 60 minutes, with 30 minutes inside the worker's regular hours. Subtracting 30 from 60 leaves 30 minutes outside those hours. Record both portions and send them to payroll for review. This arithmetic describes the timing; it does not decide which portions must be paid.

Lessons for recruiters

  1. Ask for clock times, not just dates. The example depends on the exact start and end of each trip. A note that says "travel Saturday" does not give payroll enough information to plan the trip.
  2. Compare every trip with the regular schedule. Overlap is the central feature of Chet's example, so the regular hours belong on every placement form.
  3. Treat return trips as part of the assignment. Chet's trip home is part of the example for a reason.
  4. Do not dismiss a short assignment. Include short assignments in the payroll review.
  5. Bring payroll in before the trip. Changing a plan after the worker has left is harder than setting it up correctly the first time.

Talk to the worker first

Before you confirm an assignment, talk with the worker about what the trip involves. Ask how they normally get to work, what they expect the day to look like, and whether any part of the trip conflicts with their regular hours. The worker often knows things the placement form does not show, such as a bus schedule that requires an early departure or a return trip that is not as simple as it looks on a map.

If your company checks travel distance and times for placements, tell the worker that and explain what you need from them. You do not need to give legal advice. A plain explanation is enough: you are confirming the distance and the times so the trip is recorded correctly.

Keep notes of what you told the worker and when. A short email that confirms the planned times is usually enough. Written confirmation makes it easier to correct a mistake before the trip, and it gives the worker a copy to check against their own records.

Talk to the client site

The client site also needs to know how the day works. Ask the site contact for the expected arrival time, the expected end of the day, and whether the worker will need to be on site for the full shift. If the site has its own schedule, note it, because it may differ from the worker's regular schedule and from the travel times.

Ask whether the assignment is a one-time trip or a recurring placement. Recurring trips deserve a second look, because the question of what counts as the normal fixed work location may need to be asked again as the pattern changes.

Do not promise the client that travel will be free or unpaid. Payroll and counsel should review how travel must be paid, and the client should hear that the placement plan includes that review. Setting that expectation early avoids a difficult conversation later.

A pre-placement checklist

Use this list before you send any worker more than 30 miles from the normal fixed work location:

  • Confirm the normal fixed work location and write its address in the worker's file.
  • Measure the distance to the alternate site and note the method you used. A mapping tool is fine. The goal is a record someone else can check.
  • Confirm that the employer requires the worker to report to the site, and say so in writing.
  • Get the worker's regular schedule, including days and hours.
  • Get the planned outbound and return times, to the minute if possible.
  • Mark which parts of the trip fall inside regular hours and which fall outside them.
  • Send the plan to payroll for review before the worker leaves.
  • Make sure the timesheet records actual travel times, not just planned ones.
  • Keep the review with the placement file so the next person can see how the decision was made.

For the timesheet handoff, also review time clock setup.

Common mistakes

Measuring from the wrong place. Start from the recorded location, not from a rough memory of how far the site is.

Treating the return trip as personal time. Ignoring the return journey leaves a gap in the record.

Assuming a short trip is free. Ask payroll to review it before departure.

Leaving travel off the timesheet. If travel time may be paid, it needs to be recorded. A blank line is hard to explain later.

Waiting until after the trip. By then the times are fixed, and the conversation with the worker is harder than it needed to be.

Scenarios to plan for

Some placements are less tidy than Chet's. Here are a few situations to consider, with the questions to answer before you commit.

A worker who drives their own car. Record the normal fixed work location before measuring distance. Ask payroll how your company handles mileage and any vehicle costs. This post does not cover those rules, so do not assume the answer is the same as the travel time answer.

A multi-day assignment. Each day's travel needs its own clock times. A single round-trip note on a placement form is not enough when the worker leaves and returns on different days.

A worker with a split or changing schedule. Update the regular schedule before asking payroll to review travel overlap. Update the file when the schedule changes.

A site that sits close to 30 miles. Measure carefully and record the method. A small difference in the measurement point can decide whether the rule applies at all.

A worker who takes a farther job on their own. This is not the same as an employer requirement. Check with your employment counsel before you treat it the same way as a placement you ordered.

Where federal guidance fits

Federal rules are a separate layer. The U.S. Department of Labor's Hours Worked Advisor notes that "There may be instances when travel from home to work is hours worked." That is a general federal point. Read the pages that fit your situation, and ask for help when they do not line up.

What a good placement record looks like

A good record is short enough to read in a minute and specific enough that someone else can check it. Here is the kind of note that works, using the times from BOLI's example as a model:

Worker reports normally to the fixed location, Monday through Friday, 8:00 a.m. to 5:00 p.m. Outbound trip Wednesday, 10:00 a.m. to 4:00 p.m. Return trip Saturday, 2:00 p.m. to 8:00 p.m. Overlap with regular hours to be reviewed by payroll before departure. Actual times to be entered on timesheet.

Notice what the note does not do. It does not guess at the answer. It records the facts that the answer depends on, and it names who makes the final call. That division of labor matters. Recruiters collect the facts, and payroll and counsel decide how the rule applies to the company's pay practices.

Keep the record current. If the worker's schedule changes, or the site changes, or the trip gets extended by a day, update the note and send it back through the review. A record that was accurate in March can be wrong by June if nobody touched it.

Today, choose an upcoming placement, collect its location and travel times, and send the record to payroll before confirming the assignment.

Related guides: Check pay equity before approving an offer: 5 checks · Daylight saving day pay: 6 timesheet review steps · Multi-state pay compliance: 5 checks for new hires.

Questions to take to payroll

When you send a placement to payroll, a short list of questions saves a round of back-and-forth. Consider asking:

  • Does this trip fall outside the 30-mile limit from the normal fixed work location, based on the distance we measured?

Compare the measured distance with the over-30-mile condition. Keep the measurement method with the record.

  • Which of the planned travel hours overlap the worker's regular schedule?

The overlap is the portion of travel within the worker's regular hours. Record it separately from the full trip duration.

  • How will the actual travel times be recorded on the timesheet?

Record actual outbound and return times, rather than relying on the planned schedule.

  • Does the answer change if the worker takes a different route or mode of travel?

Ask payroll to review the changed trip before applying the earlier decision.

  • Who approves the final treatment of the trip, and when?

Name the reviewer and obtain the review before departure.

Payroll may have questions of its own about the worker's regular schedule or the client's expectations. Answer them in writing where you can. A written answer is easier to find later than a phone call.

Build the decision into your process

A rule like this works best when it is part of the normal intake steps, not a one-off check. Add three fields to your placement form: the normal fixed work location, the distance to the alternate site, and the planned travel times. Then add a yes or no question: does the site sit more than 30 miles from the normal fixed work location? When the answer is yes, route the form to payroll before the assignment is confirmed.

Train new recruiters on the same example. Chet's case is short and clear, and it gives everyone a common reference point. When people use the same example, their questions are more consistent, and the file tells a clearer story if someone asks about a past placement.

Review the process once a year, or whenever the company changes where its workers report. Your list of sites and schedules will change, and the form should change with it. For related scheduling reviews, see meal break rules.

Sources