Skip forward into hiring notes
RosterAcorn

Noncompete checks before a new hire signs: 3 points

Before a new hire signs, check three noncompete points: termination or layoff, trade secret rights, and who the statute covers. Each comes from the Washington statute on employee noncompetition agreements, and each changes how you draft, talk to the applicant, and handle things after day one.

Key takeaways

  • Termination and layoff: If the employee is terminated without just cause or laid off by employer action, the noncompete is void and unenforceable — align your cause language and don't promise the new hire otherwise.
  • Trade secret rights: The statute does not restrict an employer's right to protect trade secrets or proprietary information by lawful means, so draft confidentiality as a standalone clause that doesn't depend on the noncompete.
  • Who is covered: The statute defines "employee" to include current, former, and prospective employees, as well as independent contractors — match your form to each engagement type.
  • Massachusetts retaliation point: It is unlawful to take adverse action against an employee for opposing practices they believe violate the section — treat questions about the noncompete with care and document your answers.

Why these three checks matter before the signature

You are about to send an offer letter. Tucked behind it sits a noncompete. Your new hire will sign on day one, usually with a stack of other papers. The signature takes a minute. The clause can follow them for years.

Most recruiters scan the form for typos and send it. That is a mistake. A noncompete drafted loosely can leave your company exposed, or worse, leave your new hire with a clause that will not hold up later. You want the document to do what you think it does.

This post gives you three checks to run before the new hire signs. Each one comes from an official state statute. Each one changes how you draft, how you talk to the applicant, and how you handle things after day one.

The three checks: what happens to the clause if you terminate or lay off the person, how trade secret protection relates to the noncompete itself, and who the statute counts as an employee. Those three points cover most of what goes wrong in practice.

A quick note on scope. The first two checks come from Washington's statute on employee noncompetition agreements. The third check comes from that same statute's definition section. The Massachusetts point comes from a separate statute and gets its own section.


Check one: what happens to the clause if you terminate or lay off the person

Here is the rule, in plain words: if the employee is terminated without just cause, or laid off by the employer's own action, the noncompete becomes void and unenforceable.

The exact statutory language reads: "(1) If an employee subject to an employee noncompetition agreement is terminated without just cause or laid off by action of the employer, the noncompetition agreement is void and unenforceable." The Washington State Legislature sets this out in Chapter 49.44 RCW.

Sit with that for a moment. You lay the person off. The clause dies with the layoff. You terminate them for reasons that do not qualify as just cause. The clause dies there too.

This changes how you should think about the whole document. A noncompete is not a permanent asset you can count on. It is conditional. It depends on how the relationship ends.

What to check before signing day:

  • Your termination language. Read the offer letter and the employee handbook together. Draft your cause definition with employment counsel. If your paperwork uses vague terms, tighten them.
  • Your layoff plans. If a restructuring is on the horizon for the coming quarters, know that the clause will not survive a layoff. Do not promise the applicant that it will.
  • Your communication. Tell the applicant, in plain words, that the clause has this condition. Surprises at exit are how you end up in a dispute you cannot win.

There is a practical second point hiding here. The clause being void on layoff does not mean the person walks away with nothing binding. Confidentiality terms, assignment of inventions, and other obligations can run on separate tracks. Read the document as a set of separate clauses, not one lump. For penalty exposure, see Washington noncompete penalty checks.

The Washington statute also preserves other rights. It says: "(2) Nothing in this section restricts the right of an employer to protect trade secrets or other proprietary information by lawful means in equity or under applicable law." That is the bridge to the next check.

The layoff scenario, worked through

Picture a real sequence. You hire a salesperson in March. The offer includes a noncompete. Six months later, a restructuring hits the team. The person is laid off. Under the rule above, the noncompete is void from that moment.

If you had assumed you could enforce it against them moving to a competitor, that assumption is wrong. What you can still do is rely on trade secret protection and confidentiality terms, which run on their own basis.

This is why the check matters before signing, not after. If you understand the layoff condition going in, you draft the confidentiality and invention assignment clauses with more care. You do not lean on the noncompete as your only line of defense.


Check two: how trade secret protection relates to the noncompete

Many hiring managers treat the noncompete and the confidentiality agreement as one thing. They are not. The Washington statute separates them.

The rule: the statute's restrictions do not limit an employer's right to protect trade secrets and proprietary information by lawful means, in equity or under applicable law.

In plain terms: even when the noncompete is void, the statute still leaves this right in place.

Why this matters for your paperwork:

  • Draft the confidentiality clause on its own merits. Do not let it piggyback on the noncompete. If the noncompete falls away, you want the confidentiality clause still standing.
  • Define your trade secrets. Name the categories: customer lists, pricing models, product roadmaps, source code, supplier terms. Vague clauses are harder to enforce.
  • Separate the invention assignment. If your role involves building things, the assignment of inventions clause is a distinct provision. It does not depend on the noncompete either.

There is a drafting trap here. Some standard agreements bundle everything into one paragraph that starts "the Employee agrees not to compete and further agrees to keep confidential..." If the first half of that sentence is void, a court may or may not save the second half. Do not risk it. Split the clauses.

A recruiter's job in this conversation is to explain the separation to the applicant. Applicants often hear "noncompete" and assume everything is off-limits after they leave. That is not accurate. What survives a layoff is trade secret protection. What does not survive is the restraint on where they can work.

Talk through it in the offer conversation. Not in the fine print. In the conversation.


Check three: who the statute counts as an employee

The third check sounds technical. It is the one that catches experienced recruiters off guard.

The Washington statute defines employee broadly. It says: "(8) For the purposes of this section, 'employee' means a current, former, or prospective employee or independent contractor." You can read that in Chapter 49.44 RCW as well.

Four categories sit inside that definition. Current employees. Former employees. Prospective employees. Independent contractors are in there too.

Here is what that means for your offer process:

  • Prospective employees are covered. That means the clause in the offer letter, before the person has even started, is subject to the statute's rules. You cannot avoid them by putting the agreement in a pre-hire packet.
  • Independent contractors are covered. If your standard practice is to hand the same noncompete to a contractor or a consultant, the statute treats them as employees for this purpose.
  • Former employees are covered. A termination without just cause or a layoff by employer action makes the noncompete void, so the clause can end when the person leaves.

The practical implication for you: one form does not fit every engagement. If you are onboarding a contractor alongside a full-time hire, check whether the same clause makes sense for both. The statute will treat them the same way. Your business need may differ.

A table to keep the three checks straight

Here is a compact view of the three checks and what each one tells you to do before the signature.

CheckWhat the statute saysYour action before signing
Termination or layoffNoncompete is void if terminated without just cause or laid off by employer action Align your cause language; plan around layoff exposure
Trade secret rightsEmployer's right to protect trade secrets by lawful means is not restricted Draft confidentiality as a separate, standalone clause
Who is coveredEmployee includes current, former, prospective, and independent contractor Use the right form for each engagement type

One more Massachusetts point worth knowing

If any part of your hiring touches Massachusetts, one additional provision matters. It concerns what happens when an employee speaks up.

The rule: it is unlawful for an employer to take adverse action against an employee because the employee opposes practices the employee believes violate the section, or because the employee supports another employee's exercise of rights under it. The Massachusetts statute sets this out in General Law, Part I, Title XXI, Chapter 149, Section 148C.

Read that as a warning about retaliation. You cannot treat it as a red flag. You cannot quietly move them off a project for it.

The same Massachusetts section gives enforcement to the attorney general, who may obtain injunctive or declaratory relief. That is not a private lawsuit route you want to invite. It means the state itself can step in.

For your offer process, the practical takeaway is narrow and clear: treat questions about the noncompete as good faith. Answer them honestly. Document the answers. Do not let an applicant's hesitation become a reason to pull the offer.


Putting the three checks into your offer workflow

You have the three checks. Now the question is where they live in your process.

Before the offer goes out. Read the noncompete with the three checks in mind. Confirm your cause and layoff language matches the statutory condition. Confirm the confidentiality clause stands alone. Confirm you are using the right form for the engagement type. For the wider list of conditions, see requirements for enforceable non-competes.

In the offer conversation. Walk the applicant through the three points in plain words. Tell them the clause has a layoff condition. Tell them trade secret protection runs separately. Tell them independent contractors get the same treatment under the statute.

At signing. Have them initial each major clause, not just sign the last page. It is a documentation habit that pays off if the document is ever read closely later.

After they start. Revisit the confidentiality expectations in onboarding. The noncompete is a document they signed once. Trade secret protection is a practice they live every day.

The open question

One question is still open: how "just cause" gets defined in your jurisdiction for your specific role. Ask your employment counsel how your state reads that term before you finalize the offer letter.


Quick answers to what recruiters ask most

Does the noncompete survive if I lay the person off? No. Under the Washington rule, a layoff by employer action makes the noncompete void and unenforceable. What survives is your right to protect trade secrets by lawful means, which the statute preserves. Draft that protection to stand alone.

Can I hand the same noncompete to a contractor? The Washington statute counts independent contractors as employees for its purposes. The statute's rules will apply to the contractor in the same way. Whether the clause makes business sense for a short engagement is a separate question you should think through with counsel.

What if an applicant pushes back on the noncompete during the interview? In Massachusetts, adverse action against an employee who opposes practices they believe violate the section is unlawful. For a current employee who raises the concern, treat it as protected. For an applicant, answer the concern honestly, document the conversation, and keep the process moving.

Does the Washington statute restrict my trade secret rights? No. The statute states plainly that nothing in it restricts an employer's right to protect trade secrets or other proprietary information by lawful means. That protection runs separately from the noncompete.

Who enforces the Massachusetts section? The attorney general enforces the section and may obtain injunctive or declaratory relief for that purpose.


The three checks, in one pass

Before your new hire signs, run these three checks on the noncompete.

First, plan for how the relationship could end, since the clause depends on it.

Second, confirm your trade secret and confidentiality clauses stand on their own. They do not depend on the noncompete. They are your real long-term protection.

Third, check who is covered, then match your form to the engagement.

Add the Massachusetts retaliation point if that state is in play. Then document the conversation you had with the applicant.

Pull your current offer letter and noncompete today and mark each of the three checks against it.

Related guides: I-9 name mismatch: 4 steps for a new hire's document · New hire benefits: 5 IRS rules and examples · New-hire checklist: 4 federal and Colorado checkpoints.

Sources