Oregon sets an age cut-off and a shift end time, Wisconsin uses age plus recordkeeping, and Texas sets no daily cap for most workers. Check age, job type, shift end, and weekly rest in the state where the work happens before confirming hours.
Key takeaways
- Three states set three different baselines for scheduling. Oregon uses age cut-offs and a shift end time. Wisconsin leans on age plus recordkeeping. Texas sets no daily cap for most workers.
- One Oregon rule is concrete and easy to miss: a worker at 16 years of age may be employed until 9 p.m. Check ORS 653 for the full text around that line.
- Wisconsin requires permanent employer records and blocks certain jobs for the youngest workers. See Chapter DWD 270.
- Texas allows unlimited daily hours for most adults and for youths 16 or 17, then adds a retail rest rule for full-time staff. See the Texas Workforce Commission page on work schedules.
- You can build a clean pre-schedule check that looks at state, age, job type, shift end, and weekly rest, and records the result before a shift offer goes out.
Why this matters before you set a schedule
You place teens in retail and warehouse slots. You fill seasonal shift roles fast. The pressure is real. A manager wants coverage tomorrow. An applicant wants hours this week. The risk is that a schedule looks fine and still breaks a state rule on age, end-of-shift timing, or weekly rest.
State rules do not travel. A form that works in one state can fail in the next. Oregon talks about age and a clock time. Wisconsin talks about age plus what you keep on file. Texas takes a broad free-hand approach, then carves out one retail rest rule. Those three shapes do not stack.
Treat this as a pre-flight check. Run it before you confirm hours, before you publish a roster, and before you promise a worker a block of shifts. A short check now beats a rewrite later. For a wider view, see teen work limits by state.
The three states side by side
Here is the smallest useful comparison.
| State | Age-linked limit you check first | Scheduling or rest limit in the cited source |
|---|---|---|
| Oregon | A worker at 16 years of age may be employed until 9 p.m. | Focus on the end time and age band. |
| Wisconsin | Records must be kept; jobs barred for minors under 16 in hazardous work. | No daily or weekly cap appears in the two quoted sections; keep the permanent record current. |
| Texas | No daily hour cap for most adults and for youths 16 or 17. | One 24-hour period off in seven for full-time retail employees (more than 30 hours in a week, under the statute the page cites). |
The table does not replace the state pages. It shows where the rules sit so you can open the right page at the right moment.
Oregon: check age band and end time first
Start with the age band. The line you will see most often in scheduling is that a worker at 16 years of age may be employed until 9 p.m. That comes from the Oregon Revised Statutes page for ORS 653.
Read that as a shift-end test. If the shift runs past 9 p.m. and the worker is 16, move the end time or reassign the shift. Do not split a shift across two days to get under the line without checking the statute first.
The end-time line is only one part of the statute, so you do not get a free pass on other rules. Read the surrounding rules in the same chapter for age bands, job types, and any school-related limits that may apply to your worker.
Illustrative example: a late shift for a 16-year-old
A 16-year-old is scheduled from 3 p.m. to 9:30 p.m. on a weekday. The shift ends after 9 p.m., so it fails the end-time test. Move the end to 9 p.m. or earlier, or schedule a different worker. Then log the result with the date and the name of the reviewer.
A practical Oregon workflow looks like this:
- Capture the worker's age before you offer hours.
- Flag any shift that ends after 9 p.m. for a 16-year-old.
- Confirm the job type does not sit in a restricted category in the same statute.
- Save the check in your applicant record so a second recruiter can see it.
The end-time rule is the one that trips teams up. A shift that starts in the afternoon and ends at 9:30 p.m. looks harmless on a calendar. It is not.
Wisconsin: records and job type do the work
Wisconsin leans on two things in the cited chapter: what you keep on file and what jobs you offer. The chapter title for recordkeeping is DWD 270.09 Permanent records to be kept by the employer. The full text sits in Chapter DWD 270.
Two practical consequences:
- Records. If a second reviewer, a client, or an auditor asks how you placed a minor, the file should answer without a phone call. Keep the age check, the job type, the shift times, and who approved the placement. For a sample file list, see minor-hire paperwork checks.
- Job type. DWD 270.13 blocks hazardous employment for minors under 16 years of age. If your worker is under 16, screen the job description before you schedule anything.
No daily or weekly hour cap appears in the two sections quoted here. That does not mean you can schedule any pattern you like. The chapter covers more than the two sections quoted here. Read the full chapter for age bands, permitted jobs, and any other scheduling conditions before you lock a roster.
A clean Wisconsin flow:
- Record the worker's date of birth and keep it with the placement file.
- Tag the job as hazardous or non-hazardous before you offer it to a minor.
- Store the shift times and approver in the permanent record.
- Re-check the file if the worker's age, job, or hours change mid-placement.
If your staffing agency places the same minor across multiple clients, keep one master file per person. Split records across client folders are how you lose track of what was approved.
Texas: unlimited hours, one retail rest rule
Texas takes the opposite shape. The Texas Workforce Commission work schedules page states that, with only extremely narrow exceptions relating to certain regulated industries or collective bargaining agreements, adults, as well as youths ages 16 or 17, may work, and/or may be required to work, unlimited hours each day. The only limits the page lists are employee morale, practical realities, and common sense in general.
You read that right. No state daily cap for those groups in the general case. The constraints on your roster come from somewhere else.
One exception to the unlimited hours rule in Texas is for employees in the retail sector. That is where your check changes shape.
The retail rule, as stated on that page: a retail employer must allow full-time employees at least one 24-hour period off in seven. The page points to the statute for the definition, which is more than 30 hours in a week. So each week, the employee must be allowed to have a day off.
That gives you a simple weekly test for retail placements:
- Count the scheduled hours for the week.
- If the total crosses the full-time threshold in the retail definition, confirm a 24-hour break lands inside that seven-day window.
- If the total stays under the threshold, the rest rule as written does not attach.
There is an even narrower carve-out on the same page for employees who have been continuously employed with the same retail business since August 31, 1985, under Section 52.002. For most placements you will see, that long-tenure case will not apply, but keep it in the file if a client raises it.
Practical Texas flow:
- Confirm whether the site is retail under the client's description.
- Confirm whether the worker is an adult, a youth 16 or 17, or younger.
- Count the week's hours against the full-time threshold for retail.
- Place the 24-hour break if the threshold is crossed.
Do not copy an Oregon-style end time into a Texas roster out of habit. Do not copy a Texas unlimited-hours assumption into Oregon or Wisconsin. Run the check in the state where the work happens.
A pre-schedule checklist you can run in two minutes
Use this as a short pass before you confirm hours.
- State. Confirm where the site sits. Rules follow the work location.
- Age. Capture date of birth or verified age before any offer.
- Job type. Tag hazardous or non-hazardous, especially for minors.
- Shift end. In Oregon, test any 16-year-old shift against the 9 p.m. end time.
- Weekly rest. In Texas retail, count the week's hours and place a 24-hour break if the full-time threshold is crossed.
- Record. Save age, job type, shift times, and approver in one file the next person can read.
- Change control. If hours, job, or the worker's age change after the offer, rerun the check.
This checklist lives in your applicant tracking or scheduling tool as a short form. It should take under two minutes for a routine placement. If it takes longer, the form is too long; trim it back to the fields above.
Escalation rule
If any line above turns red, pause the offer. Route the placement to a second reviewer before you send hours to the applicant. The reviewer confirms the state rule, the job type, and the record, then clears or blocks the shift. Do not let a single recruiter self-clear a red flag under deadline pressure.
What to do when a worker's age or job changes mid-placement
Mid-placement changes are common. A worker turns a year older. A client swaps a stockroom role for a floor role. Hours grow past a threshold. Each change should trigger a re-check, not a silent update.
- If age changes, rerun the age-linked test for that state before the next shift.
- If job type changes, re-tag hazardous status and re-check the Wisconsin bar for minors under 16.
- If hours grow in Texas retail, re-count the week and place the 24-hour break if the threshold is crossed.
- If the shift end moves in Oregon, test the new end time against the 9 p.m. line for a 16-year-old.
Log the re-check with a date and a name. The permanent record should show the original placement and the change, not just the final state.
Next step today: run the seven-point checklist above on one open placement and log the result.
Questions recruiters ask
What do I check first in Oregon? Age, then shift end time. Capture age before you offer hours. If the worker is 16, test any shift that ends after 9 p.m. against the line in ORS 653. Fix the end time or pick a different worker.
Does Wisconsin give me a weekly hour cap to check? No daily or weekly cap appears in the two sections quoted here. The rules covered here are recordkeeping and job type, so read the full Chapter DWD 270 for the other conditions that apply to minors.
Can I schedule a 16- or 17-year-old in Texas for any hours? Under the general rule on the TWC work schedules page, yes for daily hours, subject to the narrow exceptions the page lists. The retail rest rule still applies when the full-time threshold is crossed.
What if the site is retail but the worker is part-time? Count the week's hours. If the total is under the page's full-time threshold of more than 30 hours in a week, the rest rule as written does not attach for that week.
How do I handle a worker who turns 16 during a placement? Rerun the age-linked test for the state before the next shift. In Oregon, test the end time against the 9 p.m. line. In Wisconsin, a worker who turns 16 is no longer covered by the DWD 270.13 bar for minors under 16, so check the job against the rest of Chapter DWD 270 instead.
Where do the sources leave a question open? Some details, such as school-hour limits or exact hazardous-job lists, need the full statute or chapter. Ask the state agency or your employment counsel before you rely on a guess.
Do I need a second reviewer? Yes for any red flag: age edge, shift end, job type, or weekly rest. One person flags, a second clears. Keep both names in the record.
Closing
Run the check before you publish the roster. Age, state, job type, shift end, weekly rest. Two minutes now saves a rewrite later, and it keeps your placement file clean when someone asks how you made the call.